|
GIDGEE SNIPE BILL PLANES
To
Order this plane securely online: Hold down the Ctrl key and click
HERE.
This will open both the Secure Order Form tab and the HNT Gordon Catalogue
tab on your web browser found right at the top of this page. Click
between these tabs to 'copy and paste'
any tool(s) & prices from the web catalogue into the Secure Order Form.
Copy and Paste " Gidgee Left
Handed Snipe Bill Plane with TS blade $ 200 "
to order this plane. OR
Copy and Paste " Gidgee Right
Handed Snipe Bill Plane with TS blade $ 200 "
to order this plane. OR
Copy and Paste " Pair of Gidgee
Snipe Bill Planes with TS blades $ 380 "
to order this pair of planes. OR
Copy and Paste " Spare Left Hand TS Blade $
40 " to order this spare
blade. OR
Copy and Paste " Spare Right Hand TS Blade $
40 " to order this spare blade.
Post Australia $ 12, Post USA $ 32 to send one plane, OR
Post Australia $ 12, Post USA $54" to send a pair of planes. OR
Post Australia $ 8, Post USA $ 10 for either blade. |
These gidgee
Snip Bill Planes are 225mm long x
22 mm wide x 70mm high.
Weigh 0.6 Kg
each
and have a 3/16” thick x
1/2” wide
Tool steelblade Rc 62-64
They have a
60 degrees
blade angle for planing. The sole is a
concave 1/2" radius, 90 degree segment on
the left or right hand side of plane.
Boxed in brass to minimise wear.
Used for following marking gauge lines to form groves to start
hollow and round planes when forming furniture mouldings. They can
also form quirks to accentuate curve shapes in mouldings.
Best to have a pair of them so that you can handle any grain direction
scenario you will encounter.
Follow this link
for pictures on using these planes.
Using Snipe Bill Planes
Top Picture is the Left hand Snipe Bill Plane.
|
 |
Email:
the
Planemaker Ph: (+61) 02 6628 7222 Fax: (+61) 02 66
50 Northcott Cres, ALSTONVILLE NSW 2477
AUSTRALIA |
